A cloth cutting machine is a machine that cuts cloth and is mainly used for cutting small-sized samples or products in large quantities. Fabric cutting machine is widely used in the corresponding textile industry, such as garment factories, fabric dealers and so on. Fabric cutting machine can be widely used for cutting fabrics, leather, cotton textiles, hard paper and other similar materials.
Now, let's take a look at fabric cutting machine operation process:
1. Turn on the air pump switch, turn on the air source, pull up the manual air pressure switch on the left side of the console, and raise the cloth pressing roller.
2. Put the compounded finished blanket under the cloth pressing roller, press the manual air pressure switch on the left side of the operating table, the cloth pressing roller will drop down and press the blanket. Note that hands should be placed on the outside of the fabric during operation to avoid crushing your fingers.
3. Set the motor/manual switch on the console to the manual position, turn on the power supply, adjust the inverter knob on the left side of the console to adjust its value to about 18-20HZ, adjust the inverter knob on the right side of the console, and turn it The value is adjusted to about 2.45---2.55HZ. Adjust the light control on the conveyor frame to the appropriate size of the electric blanket.
4. Open the cabinet door under the operating table, there are one three-phase switch and one single-phase switch, close the switch, and the cloth cutting machine starts to run.
5. To ensure that the pattern point of the blanket is parallel to the cloth pressing roller and the cutting knife groove, pay attention to observe the running track of the blanket material. When the pattern point runs to the left cutting edge of the cloth cutting groove, quickly turn the manual switch to the motor position. The cloth cutting machine starts to run automatically.
6. The operator should always pay attention to observe the size of the cut blanket and the cutting position of the blanket.
Here's how fabric cutting machine is maintained and maintained:
1. Check whether the grounding of the machine casing is good once a week.
2. Check whether the cloth cutting blade is sharp every day, if not, grind it with a grinding stone.
3. Check the air circuit daily for leaks.
4. Check the electrical circuit once a month to keep the insulation in good condition.
5. The reducer should be replaced with lubricating oil every six months.
6. After the motor has been used for one year, the grease should be replaced.
7. The chain should be kept lubricated normally and tensioned in time; the transmission gear and the worm gear should be greased once a week.
8. When the machine is not used for a long time, pay attention to moisture-proof and rat-proof.
9. The work should clean up the dirt stuck on the pressure roller in time, so as not to make it difficult to clean for a long time.
10. Carefully clean up after get off work every day to ensure smooth operation of the equipment.
If you are interested in fabric cutting machine, and if it’ s needed in your factory. You can also view our Suntech’ s official website: https://www.suntech-machine.com/. We have many kinds of fabric cutting machine, I think there must be one type will fit your requirments. For any other questions, please feel free to contact us if you have any inquiries about this fabric cutting machine.